48V Quick start guide

48V Quick start guide 2024-01-21

No permission to download
A: Preparation:

• FULLY CHARGE BATTERIES PRIOR TO INSTALLATION.

• ONCE CHARGED, POWER THE BATTERIES OFF.

• ENSURE THE CART IS TURNED OFF.

• TAKE PHOTO OF EXISTING CONNECTIONS FOR REFERENCES.


B: Removal:

• DISCONNECT CABLES FROM EXISTING BATTERIES.

• REMOVE THE BATTERIES WITH INCLUDED STRAP.

• CLEAR COMPARTMENT OF CORROSION / DEBRIS.



1. Installation

A: BALANCE YOUR BATTERIES


Batteries cannot be shipped with a full charge, and in rare occasions can be unbalanced with another battery in your kit, This may display a voltage related alarm indication on your gauge.

Additionally, battery cables “NOT” connected to the BUS-BARS precisely as shown on your installation sheet, can also cause batteries to become unbalanced.


IMG_2183.jpeg




A: Quick Start Guide

Busbar contains two bars with four posts each. One bar will be dedicated to positive connections and the other negative / ground.

• Connect the cables from the first battery to first post of each bar.

• Connect the charger leads to the second post of each bar.

• Connect the cables from the second battery to the third post of each bar.

• The final post of each bar will be dedicated to cart connections (controller and solenoid). If cart has aftermarket 12V accessories, the yellow and …See more


IMG_2085.jpeg


This quick start guide will get you on the right path to getting your installation plan in place, and your batteries ready for final installation.



IMG_2086.jpeg


IMG_2087.jpeg



4. Bluetooth Monitoring

Follow this guide graph only if you are going to not be installing the can bus fuel gauge, and monitor the system via Bluetooth only

IMG_2076.jpeg
  • Like
Reactions: jww24
Author
administrator
Downloads
0
Views
362
First release
Last update
Rating
0.00 star(s) 0 ratings

More resources from administrator

Back
Top